Tighten Garage Door Spring

If it was opening too quickly move it to the next lower hole.

Tighten garage door spring.

If the door was closing too quickly move the spring to the next higher hole on the bracket. Locate a reddish color cone around the spring. Put on eye. This tension makes it easier to lift the garage door from its closed position.

It should be placed on the left hand side of the torsion spring and placed away from the garage door s center. Once the screws are loosened place the second metal rod into an opposite notch on the cone and turn both rods to the right or to the left depending on whether you are tightening or loosening the tension. Once your garage door is secured remove the spring hook from the track hanger which will allow you to move the hook and adjust the spring s tension. Adjust the springs on both sides of the door the same way.

Release your hold on the door and see if it stays up all the way. Take note of the notches and screws that hold the torsion spring in place. Step 1 unplug the garage door opener and clamp the door to the track. Slowly close your door about halfway and release it.

Through the use of pulleys they perform the same function as the torsion springs. This can make the other parts of the garage door last a much longer time. They come under tension when the garage door is closed to make lifting the. Use locking pliers or a c clamp to secure the door to the track to keep it from opening when you release the tension on the springs 1 x research sourcestep 2 loosen the set screws while holding each spring with a winding bar.

Disconnect the garage door opener so the door remains closed. Next get hold of one of the tension rods and push it into the first notch. To adjust your garage door s side mounted springs first open your door fully and secure it in place with a c clamp below the bottom roller. How to safely adjust your garage door spring.

Once the spring is free of tension remove from its track hanger. Position a sturdy ladder to the side of the springs rather than working directly in front of them for safety reasons. The springs extend along the shaft and work by twisting as the garage door closes by means of cables attached to each side of the lowest garage door panel. If the garage door easily swings open and closed then it will need to be tightened.

Turn the rods to the right. Ideally the door should slowly float up from this point.